2 Inch 50mm Formula 4x4 Core Lift Kit with Height Adjustable ReadyStruts to suit Ford Ranger PX III 2018-2022
2 Inch 50mm Formula 4x4 Core Lift Kit with Height Adjustable ReadyStruts to suit Ford Ranger PX III 2018-2022
Upgrade your Ford Ranger PX III with the RANG-503R Formula 4x4 Core Lift Kit, developed to improve ride height, ground clearance, handling and suspension control across sealed roads, touring routes and recreational off-road terrain.
This vehicle-specific package now features the RANGER24-FOR-ADJ Formula 4x4 height-adjustable front ReadyStrut kit, combined with matching Formula 4x4 rear shock absorbers and supporting SuperPro components.
The pre-assembled height-adjustable ReadyStruts allow the front ride height to be fine-tuned during installation to suit vehicle setup, permanent accessory weight and preferred stance, while providing the convenience of a complete front spring and strut assembly.
Key Features
- Formula 4x4 height-adjustable front ReadyStruts
- Pre-assembled front spring and strut assemblies
- Front ride height can be fine-tuned during installation
- Approximately 50mm suspension lift depending on vehicle condition, load and selected front ride-height setting
- Formula 4x4 rear shock absorbers for improved damping and suspension control
- Improved ground clearance, handling and vehicle stability
- SuperPro rear spacer and centre bearing alignment components included
- Heavy-duty suspension performance suited to Australian touring and recreational 4WD use
Kit Contents
- 1 x Formula 4x4 height-adjustable front ReadyStrut kit RANGER24-FOR-ADJ
- 2 x Formula 4x4 rear shock absorbers 50002
- 1 x SuperPro rear spacer kit TRC169RLK
- 1 x SuperPro centre bearing alignment kit SPF4659K
Formula 4x4 Height-Adjustable ReadyStruts
The RANGER24-FOR-ADJ front ReadyStruts are supplied fully pre-assembled, providing a matched front suspension assembly that removes the need to dismantle or assemble the front spring and strut components before installation.
The height-adjustable front configuration allows the final ride height to be fine-tuned during installation to suit the vehicle's permanent accessory weight, suspension setup and preferred stance.
Formula 4x4 shock absorbers are tuned to provide a comfortable yet controlled ride, with heavy-duty construction suited to touring, towing and recreational off-road use.
Important Fitment Information
RANG-503R is designed to suit applicable Ford Ranger PX III models from 2018-2022.
Suitable for PX III applications.
Confirm the exact vehicle model, build date, drivetrain, suspension configuration and permanent accessory load before ordering or installation.
Final ride height may vary depending on vehicle condition, permanent accessories, operating load and the selected front ReadyStrut height setting.
After purchase, a Fulcrum Suspensions specialist will contact you to confirm your vehicle details, intended use, permanent accessory load and suspension requirements to help ensure the supplied suspension package is appropriate for your vehicle.
When purchasing through our Click & Fit service, we will also confirm your preferred installation location and booking date.
Formula 4x4 Lift Kit Warranty
Formula 4x4 lift kits are covered by a 5-year warranty, subject to the applicable warranty terms and conditions.
Activate your warranty online and learn more here.
Premium Lift Kit Packaging & Shipping
This lift kit is supplied through Fulcrum Suspensions' Premium Packaging service to help protect the suspension components during transit.
Premium Packaging applies to available Deliver to Door, Click & Fit and Free Pickup through Click & Collect options. Learn more about our premium lift kit packaging here.
For product or fitment assistance, call 1800 385 278.
Lift Kit Fitting Instructions
General fitting instructions and warranty information are supplied with the kit. Professional installation by a qualified mechanic or suspension technician is strongly recommended, preferably at a workshop with wheel-alignment facilities.
A wheel alignment should be completed after installation to confirm steering geometry, handling and tyre wear.
Springs & Lift Heights
The springs create the lift, so selecting the correct front and rear spring rates is essential for achieving a level stance, comfortable ride and reliable suspension performance. While the kit title specifies a lift height, the final front and rear height increase will depend on your vehicle’s permanent accessories, constant load and intended use.
After you place your order, a Fulcrum Suspensions specialist will contact you before processing it. We will confirm your vehicle details, accessories, regular load, towing requirements and driving conditions to ensure the correct springs are supplied.
A constant load is any weight permanently fitted to or carried in the vehicle, such as bull bars, winches, bash plates, batteries, drawers, canopies, tools and recovery equipment. Engine type and other vehicle specifications can also affect spring selection. Where possible, install all permanent accessories before fitting your lift kit so the suspension can be matched correctly from the outset.
The spring rating should closely match the vehicle’s actual constant load. For example, a vehicle carrying approximately 250kg permanently should use a spring designed for that load range.
Springs rated below the vehicle’s constant load may become overloaded, causing sagging or premature failure. This can also occur when towing, as caravan, boat or trailer ball weight adds load to the rear suspension.
Springs rated substantially above the actual load can produce an excessively firm ride and may contribute to issues such as shock absorber top-out or coil spring trapping. The front and rear springs must also be correctly matched, as an unsuitable spring rate at either end can leave the vehicle sitting nose-high or nose-low.
For occasional additional loads or towing, an airbag helper kit may be recommended. Airbags support the springs when carrying temporary loads but do not replace correctly rated springs and are not designed to carry the vehicle’s load on their own.
There is no need to determine every specification yourself. Our suspension specialists will review your requirements after purchase and confirm the most suitable configuration for your vehicle.
For assistance before ordering, contact us through online chat or call our team.
| SKU | RANG-503R |
|---|---|
| Foot Note 1 | Kit contains: Formula 4x4 ReadyStrut Kit RANGER24-FOR-ADJ x 1, Formula 4x4 Shocks 50002 x 2, SuperPro Spacer Kit TRC169RLK x 1, SuperPro Centre Bearing Alignment Kit SPF4659K x 1 |
| Foot Note 2 | to suit PX III |
| Components Per | 1 Kit |
| Sub brand | Formula 4x4 |
| EAN | 9317745843702 |
| Warranty | 5 years warranty |
Downloads
Product Stock
Please be advised that our stores do not hold any stock. In order to make sure things go as fast as possible you can purchase your parts online. If you would like to have your parts installed by us please choose Click & Fit at the checkout.
You can use the shipping calculator to find your shipping costs, your closest pick up or install locations. The shipping calculator will also show all shipping and installation prices. Shipping is free if you choose to get your item installed by us.
When our product stock levels are low, or current stock is allocated to orders, our website may show an ‘in-stock’ status when in fact the item might be sold out. We will advise within 48hrs; stock availability, order status and shipping details.
Delivery Methods
1. Select “Click & Fit” as a delivery method during the checkout process and you will be given a special fitted price to have both the product delivered and installed. A suspension expert will be assigned to your order, who will organise everything for you and will help you every step of the way. You can sit back and relax, knowing that your car is going to be looked after by suspension experts.
2. Select “Free Pickup” as a delivery method during the checkout process and you will be given free delivery to your nearest Fulcrum outlet where you can collect the parts. We will text and email you all your tracking details.
3. Select “Deliver to Door” as a delivery method during the checkout process and we will deliver your order direct to your nominated delivery address. We will text and email you all your tracking details.
Shipping
We offer FREE shipping to all metro areas (excluding WA, TAS and NT).
If you live on the Australian coast, that does not mean you are subject to free shipping.
Express shipping times and free shipping times are only to be counted once the order has been shipped from our warehouses. Our free shipping and express shipping services both have the same order processing times. We first have to raise the order, then we send it to one of our warehouses for processing and once ready it will be shipped from the warehouse. The difference between express and free shipping services, is the time it takes for the item to be transported from our warehouse to your address.
Our free shipping policy is determined by densely populated metro locations and the viability of distance travelled from our distribution centres. We are constantly expanding our warehousing, so areas covered by free shipping are subject to change. See our shipping policy here.
Returns
We guarantee the fitment and quality of our products, but if you choose to return an item we offer a generous 60 day returns policy. See our returns policy here.
Warranty
All products sold by Fulcrum Suspensions are covered by a national warranty. This products warranty is subject to conditions from the date of purchase, unless otherwise stated on the item.
Warranty claims must meet certain criteria and be sent to Fulcrum Suspensions with a receipt to be eligible for a refund. See full warranty claim criteria here.